Ideal fault code
Ideal F1: low water pressure
You can usually fix thisChecked against 2 sources ยท Updated November 2026
The boiler has stopped because the water pressure is low. Ideal says to check the gauge reads between 1 and 1.5 bar and repressurise if it doesn't.
Safe checks you can do
- Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
- Top the pressure up if it's low. Open the filling loop slowly and watch the gauge. Stop at about 1.5 bar, close both valves fully, then reset the boiler. How to do this
- Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this
Common causes
- Normal pressure loss over time
- Radiators recently bled
- A leak in the system
- The pressure relief valve letting water out
When to call an engineer
Ideal says that if the pressure keeps falling it could mean a leak. Book an engineer if you're topping up regularly.
Need an engineer?
For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).
Can I fix Ideal F1 myself?
Usually, yes. It's normally something you can sort yourself with the checks on this page.
How to reset a Ideal boiler
Turn the dial to the reset position for about five seconds, then back. Newer models have a reset button. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.
Sources
We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.