Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Vaillant fault code

Vaillant F.83: temperature not rising as expected

Try the checks, then call an engineer

Checked against 2 sources ยท Updated November 2026

What it means

When the burner lit, the temperature sensors on the pipes going out of and back into the boiler barely changed. The manual describes this as the temperature difference between the flow and return sensors being too small, often because there isn't enough water in the boiler.

Safe checks you can do

  1. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  2. Top the pressure up if it's low. Open the filling loop slowly and watch the gauge. Stop at about 1.5 bar, close both valves fully, then reset the boiler. How to do this
  3. Bleed air out of the radiators. Radiators that are cold at the top have air in them. Bleed them with a radiator key, then check the pressure again, because bleeding lowers it. How to do this
  4. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Common causes

  • Low water pressure or very little water in the boiler
  • Air in the system
  • A temperature sensor that has come loose or failed

When to call an engineer

If the pressure is correct and the code keeps returning, an engineer needs to check the sensors and pump.

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Can I fix Vaillant F.83 myself?

Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.

How to reset a Vaillant boiler

On most Vaillant models press the reset button (the circular arrow) once. Some ranges reset from the menu. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.